Memory Mode; Memory Channel Selection - Icom IC-820H Instruction Manual

MEMORY MODE 8&8
#2 Memory channel! selection
@) Push [MEMO] to select the memory mode.
- "MEMO" appears.
@ Push [DOWN] or [UP] to select the desired
memory channel.
- The tuning dial can also be used for memory chan-
nel selection. While pushing [MEMO], rotate the
tuning dial.
3) To return to the VFO mode, push [VFO].
Memory channel programming can 'be performed
either in the VFO mode or in the memory mode.
¢ Programming in the VFO mode [EXAMPLE] : Programming 144.275 MHz/USB into
memory channel 12.
(@) Set the desired frequency and operating mode in
the VFO mode. Set the desired
- Tone frequency, offset frequency, etc., can also be
PouEote
S
programmed.
(@) Push [DOWN] or [UP] to select the desired
memory channel to be programmed.
- The tuning dial can also be used while [MEMO] is Select memory
pushed. Motel OU i channel number 12.
(3) Push and hold [MW] for 2 sec. to program the Ae ne tes
displayed frequency and operating mode into the MCE
memory channel.
To check the programmed contents, push [MEMO]
to select the memory mode.
e Programming in the memory mode [EXAMPLE] : Programming 145.750 MHz/FM into
memory channel 18.
@) Push [MEMO] to select the memory mode.
(2) Select the desired memory channel to be pro- SSeneneN
grammed with the [DOWN] or [UP] switch. channel 18.
- The tuning dial can also be used while [MEMO] is
pushed. .
Set the desired frequency and operating mode in
the memory mode.
- Tone frequency, offset frequency, etc., can also be
programmed.
- Blank channels cannot be programmed in the
memory mode. Select the VFO mode in advance, M-CL
then program blank channels. (push for 2 sec.)
Push and hold [MW] for 2 sec. to program the Push and hold [MW] to
displayed frequency and operating mode into the
memory channel.
Set the desired
frequency and mode.
30