Initial Set Mode Items - Icom IC-T70A Instruction Manual
Vhf/uhf dual band fm transceiver
Hide thumbs
Also See for IC-T70A:
- Service manual (41 pages) ,
- Instruction manual (11 pages) ,
- Product review (3 pages)
Table of Contents
Advertisement
9
SET MODES
D VOX delay (VOX.DLY)
Sets the VOX delay to between "0.5," "1.0," "1.5," "2.0," "2.5"
and "3.0" seconds.
The VOX delay is the amount of time the transmitter stays
ON after you stop speaking.
D VOX time-out timer (VOXTOT)
Sets the VOX time-out timer to between 1, 2, 3, 4, 5, 10 and
15 minutes to prevent accidental prolonged transmission for
the VOX function.
To turn the function OFF, select "OFF."
The VOX time-out timer must be set shorter than the time-
out timer, otherwise this timer will not be activated.
59
■ Initial set mode items
D Microphone simple mode (MIC S)
Microphone simple mode is used to assign the essential op-
erations to the four switches (S1 to S4) on the remote con-
trol unit. (p. 82)
• SImPLE
(default: 0.5)
• nORm-1 (default)
• nORm-2
D Auto power OFF (AP OFF)
The transceiver can turn itself OFF automatically after a
specified time. Activating a control restarts the time-out. The
(default: 3)
transceiver beeps before turning OFF.
30, 60, 90, 120 minutes and OFF can be specified. The spec-
ified period is retained even when the transceiver is turned
OFF by the auto power-off function. To cancel the function,
select "OFF."
(default: OFF)
Advertisement
Table of Contents
Need help?
Do you have a question about the IC-T70A and is the answer not in the manual?
Questions and answers
How to set aicom t70a to repeater
To set the Icom IC-T70A to repeater mode:
1. Set the receive frequency (repeater output frequency).
2. Set the shift direction of the transmit frequency (-DUP or +DUP).
3. Push [PTT] briefly, then push and hold [PTT] again for 1 to 2 seconds to transmit a 1750 Hz tone burst signal (if required).
4. If "OFF" appears, check the frequency offset or shift direction.
This answer is automatically generated