How To Set Parameters; Setting Parameters In The Selected Quick Mode - Toshiba TOSVERT VF-AS1 Instruction Manual

4.1

How to set parameters

This section explains how to set parameters, while showing how parameters are organized in each setting monitor
mode.

4.1.1 Setting parameters in the selected quick mode

To place the inverter in this mode, press the
Note that extended parameters are not displayed in the quick mode.
Standard monitor mode
4
How to set basic parameters
(1) Selects parameter to be changed. (Press the
(2) Reads the programmed parameter setting. (Press the
(3) Change the parameter value. (Press the
(4) Press this key to save the change. (Press the
Adjustment range and display of parameters
: An attempt has been made to assign a value that is higher than the programmable range. Or, as a result of
changing other parameters, the programmed value of the parameter that is now selected exceeds the upper
limit.
: An attempt has been made to assign a value that is lower than the programmable range. Or, as a result of
changing other parameters, the programmed value of the parameter that is now selected exceeds the lower
limit.
If the above alarm is flashing on and off, no setting can be done of values that are equal to or greater than
to or lower than
ENT key
Used to set values
and return to
previous menu
.
key (the LED lights up), and then press the
EASY
Quick mode (EASY)
Title
Registered parameter display selection
* Parameter title and the setting
value are displayed alternately.
Select key Mode key
Used to select Used to select mode
item and operation level
or key.)
key.)
ENT
or key.)
key.)
ENT
D-2
E6581301
key.
MODE
Function
Automatic function setting
V/f control mode selection
Maximum frequency
Acceleration time 1
Deceleration time 1
Motor overload protection level 1
FM terminal meter adjustment
*
or equal