Braking Function - Toshiba TOSVERT VF-AS1 Instruction Manual

6. 17

Braking function

: Braking mode selection
: Load portion torque input
selection
: Hoisting torque bias input
: Lowering torque bias multiplier
• Function
These parameters can be used as brake sequences for lifts and similar equipment.
To ensure smooth operation, the motor produces enough torque before the brake is released.
Title
Braking mode selection
Load portion torque input selection
Hoisting torque bias input (valid
only when
Lowering torque bias multiplier
Brake release time
Creeping frequency
Creeping time
Braking time learning function
Starting procedure
At the run command, the inverter makes the motor produce the torque specified with parameter
a torque output command is issued, a brake release request signal is put out through the brake output terminal.
Upon expiration of the brake release time set with
Function
:Deselect
:Forward winding up
:Reverse winding up
:Horizontal operation (counter weight)
:Disabled
:VI/II (voltage/current input)
:RR/S4 (potentiometer/voltage input)
:RX (voltage input)
:
:2-wire RS485 input enabled
:4-wire RS485 input enabled
:Communications option input enabled
:A1 (differential current input)
-
= )
~
:Deselect
:Brake signal learning (0 after adjustment)
F-29
: Brake release time
: Creeping frequency
: Creeping time
: Braking time learning function
Adjustment range
enabled
~ %
%
~ sec.
~ Hz
~ sec.
, the motor starts to accelerate.
E6581301
Default setting
6
. As soon as