Toshiba TOSVERT VF-AS1 Instruction Manual page 162

Setting parameters
a) Operating method: Terminal input
Set the command mode selection
b) Use the S2 and S3 terminals for switching. (Instead, other terminals may be used.)
S2: Acceleration/deceleration switching signal 1
S3: Acceleration/deceleration switching signal 2
Title
Acceleration/deceleration pattern
Acceleration/deceleration patterns can be selected individually, using the acceleration/deceleration 1, 2, 3 and 4
parameters.
1) Straight acceleration/deceleration
2) S-pattern acceleration/deceleration 1
3) S-pattern acceleration/deceleration 2
Title
6
1) Straight acceleration/deceleration
A general acceleration/deceleration pattern.
This pattern can usually be used.
2) S-pattern acceleration/deceleration 1
Select this pattern to accelerate/decelerate the motor rapidly to a high-speed region with an output frequency of
60Hz or more or to minimize the shocks applied during acceleration/deceleration. This pattern is suitable for
conveyer machines.
Output frequency [Hz]
Maximum frequency
Set frequency
0
×
Both the S-pattern lower-limit setting (
affect all acceleration/deceleration pattern settings.
Function
Input terminal function selection 6 (S2)
Input terminal function selection 7 (S3)
Function
Acceleration/deceleration 1 pattern
Acceleration/deceleration 2 pattern
Acceleration S-pattern lower limit
adjustment
Acceleration S-pattern upper limit
adjustment
Deceleration S-pattern lower limit
adjustment
Deceleration S-pattern upper limit
adjustment
Acceleration/deceleration 3 pattern
Acceleration/deceleration 4 pattern
Output frequency [Hz]
Maximum frequency
Actual acceleration time
×
%
to .
Adjustment range
~
~
Adjustment range
:Straight, :S-pattern 1,
:Straight, :S-pattern 1,
~ %
~ %
~ %
~ %
:Straight, :S-pattern 1,
:Straight, :S-pattern 1,
0
Output frequency [Hz]
Maximum frequency
Set frequency
0
Time [s]
% ×
, ) and the S-pattern upper limit setting (
F-50
E6581301
Example of setting
(Acceleration/deceleration
switching signal 1)
(Acceleration/deceleration
switching signal 2)
Default setting
:S-pattern 2
:S-pattern 2
:S-pattern 2
:S-pattern 2
Time [s]
Time [s]
Actual deceleration time
% ×
,
%
)