Toshiba TOSVERT VF-AS1 Instruction Manual page 85

Below is an example of 7-step speed operation.
Output
frequency [Hz]
0
ST-CC
F-CC
S1-CC
S2-CC
S3-CC
4)Setting the operation mode
An operation mode can be selected for each preset speed.
Operation mode setting
Title
Preset speed operation mode
selection
: Preset speed operation with no mode ¥ ¥ ¥ ¥ ¥
: Preset speed operation with mode ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥
If you selected "enabled" (
following terminal F, R.
Operation mode setting
Title
Preset speed
~ operation frequency
1~15 operation mode
For the settings marked with +, more than one function can be selected at the same time by entering the sum of
the numbers of the desired functions.
Ex.) (+ ) + (+ ) =
By entering " ", you can activate the reverse run function and the acceleration/deceleration switching signal 1
function at the same time.
Example of 7-step speed operation
Function
: Preset speed operation with no
mode
: Preset speed operation with
mode
Only frequency commands are governed by the preset
speed command (1 to 15) entered.
The direction of rotation, the V/f control mode, the
acceleration and deceleration times and the torque limit
can be set individually for each preset speed command.
= ), the motor runs operation mode setting directions as below without
Function
: Forward run
+ : Reverse run
+ : Acceleration/deceleration switching
signal 1
+ : Acceleration/deceleration switching
signal 2
+ : V/f switching signal 1
+ : V/f switching signal 2
+ : Torque limit switching signal 1
+ : Torque limit switching signal 2
E-19
Adjustment range
Adjustment range
E6581301
Time
[s]
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
5
OFF
Example of setting
Example of setting