7.2.3 Setup of input terminal operation time
•Function
The input/output terminal operation time setup function is used to extend response time if there is something
malfunctioning because of noise or chattering of input relay.
Setup of response time
Title
:
Setting when vector option unit or expansion terminal board option is used.
Note: The minimum setting unit is 1ms. Please input the value which omitted below the decimal point of a multiple of
2.5.
7.2.4 Analog input filter
•Function
This function is effective to remove noise from the frequency setting circuit. If operation is unstable because of
noise, increase the time constant of the analog input filter.
Response time setting
Title
Function
Input terminal 1 response time selection (F)
Input terminal 2 response time selection (R)
Input terminal 3 response time selection
(ST)
Input terminal 4 response time selection
(RES)
Input terminal 5~12 response time selection
Input terminal 13~20 response time
selection
Function
Analog input filter
G-9
Adjustment range
~
~
~
~
~
~
Adjustment range
:No filter
:Filter approx. 10ms
:Filter approx. 15ms
:Filter approx. 30ms
:Filter approx. 60ms
E6581301
Default setting
ms
ms
ms
ms
ms
ms
Default setting
7