Loading And Unloading Media Rolls - Oce Arizona 350 User Manual

Loading and Unloading Media Rolls

Loading rolls of media is a step-by-step procedure that is not as simple as for
typical inkjet printers, but it is nevertheless a straightforward procedure.
Check that the media is evenly rolled on the core with no bumps or
extrusions. Also check that it is aligned to avoid telescoping (lateral
displacement) as it winds onto the take-up shaft.
1. Place an empty media shaft on a suitable flat work area, positioned as
shown, so that the hex key is inserted on the right side of the shaft to lock and
unlock the core locks.
2. Slide a new roll of media onto the supply shaft.
3. Roughly center the roll on the shaft, and then insert the shaft into the
supply (bottom) position on the printer.
4. Accurately center the media using the supplied ruler.
5. Lock the supply media shaft core locks with the hex key.
6. Load an empty core and install in the take-up position
7. Thread the media by selecting the Load icon from the Roll Media Manager.
8. Wait for the gantry to move part way across the table.
Copyright © 2008 BERTL, Inc.
All Rights Reserved. The license under which this document is made available and applicable law prohibit any reproduction or further transmission of any portion of this document. This
document may only be viewed electronically through the www.BERTL.com Web site and may not be stored in electronic or hard copy format. Any reproduction of trademarks is strictly
prohibited. BERTL accepts no responsibility for any inaccuracies or omissions contained in this document.
WideFormat
March 8, 2009
Océ Arizona 350 GT Printer
www.bertl.com
9. Continually press on the right foot
pedal, as required, to gradually advance
the media for the next two steps.
10. Thread the media under the media
tension bar.
11. Open the media access door at the
top of the Roll Media unit, then reach
down through the open door to grasp the
media and feed it up and over the take-up
roll.
12. Check alignment of the media by
feeding it down to the supply roll and
make sure that the edge lines up with the
edge of the supply roll.
13. Rewind the media by continually
pressing down the left foot pedal until it is
positioned where it can be taped to the
take-up core.
March 8, 2009
Page 25