3.3: DIN Installation Steps
DIN INSTALLATION STEPS:
1. Slide meter with NEMA 12 Mounting Gasket into panel. (Remove ANSI Studs, if in place.)
2. From back of panel, slide 2 DIN Mounting Brackets into grooves in top and bottom of
meter housing. Snap into place.
3. Secure meter to panel with lock washer and a #8 screw through each of the 2 mounting
brackets. Tighten with a #2 Phillips screwdriver. Do not overtighten.
e
Electro Industries/GaugeTech
#8 Screw
Shark 100 Meter
with NEMA 12
Mounting Gasket
Remove (unscrew)
ANSI Studs for
DIN Installation
Doc #: E145701
DIN Mounting
Bracket
Top Mounting
Bracket Groove
Bottom Mounting
Bracket Groove
Figure 3.8: DIN Mounting Procedure
3-3