Electro Industries Shark 100 Installation & Operation Manual page 76

7.3.4: Operating Mode
Operating Mode is the Shark 100 meter's Default Mode. After Start Up, the meter automatically
scrolls through these parameter screens, if scrolling is enabled. The screen changes every 7 seconds.
Scrolling is suspended for 3 minutes after any button is pressed.
Push the DOWN Button to scroll all the parameters in Operating Mode.
The 'Active" parameter has the Indicator light next to it on the right face of the meter..
Push the RIGHT Button to view additional readings for that Parameter.
A Table of the possible readings for Operating Mode is below.
See Appendix A (Sheet 2) for the Operating Mode Navigation Map.
Parameter
Designator
Available by
V-Switch
VOLTS L-N V1-4 VOLTS_LN
VOLTS L-L V1-4 VOLTS_LL
AMPS V1-4 AMPS
W/VAR/PF V2-4 W_VAR_PF
VA/Hz V2-4 VA_FREQ
Wh V3-4 KWH_REC
KVARH_
VARh V3-4
POS
VAh V3-4 KVAH
NOTE: Reading or Groups of readings are skipped if not applicable to the meter type or hookup, or if
explicitly disabled in the programmable settings.
e
Electro Industries/GaugeTech
OPERATING MODE PARAMETER READINGS
Possible Readings
VOLTS_LN_ VOLTS_LN_
MAX MIN
VOLTS_LL_ VOLTS_LL_
MAX MIN
AMPS_
AMPS_MAX
NEUTRAL
W_VAR_PF W_VAR_PF
_MAX_POS _MIN_POS
VA_FREQ_ VA_FREQ_
MAX MIN
KWH_DEL KWH_NET
KVARH_ KVARH_
NEG NET
Doc # E145701
AMPS_MIN
W_VAR_PF W_VAR_PF
_MAX_NEG _MIN_NEG
KWH_TOT
KVARH_
TOT
V4 Only
VOLTS_LN
_THD
AMPS_THD
7-10