Table of Contents
Advertisement
3.3: DIN Installation Steps
1. Slide meter with NEMA 12 Mounting Gasket into panel. (Remove ANSI Studs, if in place.)
2. From back of panel, slide 2 DIN Mounting Brackets into grooves in top and bottom of
meter housing. Snap into place.
3. Secure meter to panel with lock washer and a #8 screw through each of the 2 mounting
brackets. Tighten with a #2 Phillips screwdriver. Do not overtighten. The maximum installation torque
is 0.4 Newton-Meter.
e
Electro Industries/Gauge Tech
DIN Mounting Bracket
Top Mounting Bracket Groove
Bottom Mounting Bracket Groove
Shark ® 200 Meter
with NEMA 12 Mounting
Gasket
Remove (unscrew) ANSI
Studs for DIN Installation
Figure 3.8: DIN Mounting Procedure
Doc# E149701
#8 Screw
3-4
Advertisement
Table of Contents
