Table of Contents
Advertisement
Configuring the Shark Using the Front Panel
7.1: Overview
The Shark 100 front panel can be used to
configure the meter. The Shark has three
MODES:
Operating Mode (Default),
Reset Mode and
Configuration Mode.
The MENU, ENTER, DOWN and
RIGHT buttons navigate through the
MODES and navigate through all the
SCREENS in each mode.
In this chapter, a typical set up will be
demonstrated. Other settings are
possible. The complete Navigation
Map for the Display Modes is in
Appendix A of this manual. The meter
can also be configured with software
(see Communicator EXT 3.0 Manual).
7.2: Start Up
Upon Power Up, the meter will display a sequence of
screens. The sequence includes the following screens:
Lamp Test Screen where all LEDs are lighted
Lamp Test Screen where all digits are lighted
Firmware Screen showing build number
Error Screen (if an error exists)
Shark 100 will then automatically Auto-Scroll the
Parameter Designators on the right side of the front
panel. Values are displayed for each parameter.
The KILO or MEGA LED lights, showing the scale
for the Wh, VARh and VAh readings.
An example of a Wh reading is shown here.
The Shark 100 will continue to scroll through the Parameter Designators, providing readings until
one of the buttons on the front panel is pushed, causing the meter to enter one of the other MODES.
e
Electro Industries/GaugeTech
Chapter 7
Reading Type Indicator
IrDA
Comm
Port
% of Load Bar
Doc # E145701
Parameter Designator
Figure 7.1: Shark Label
Figure 7.2: Wh Reading
Watt-
Hour
Test
Pulse
Scale Selector
7-1
Hide quick links:
Advertisement
Table of Contents
