Table of Contents
Advertisement
11. When the driver installation is complete, you will see the screen shown below.
12. Click Finish to close the Found New Hardware Wizard.
IMPORTANT! Do NOT remove the Installation CD until the entire procedure has been
completed.
13. Position the USB to IrDA Adapter so that it points directly at the IrDA on the front of the Shark
100 meter. It should be as close as possible to the meter, and not more than 15 inches/38 cm away
from it.
14. The Found New Hardware Wizard screen opens again.
E Electro Industries/Gauge Tech
Doc# E145721
®
E-4
Hide quick links:
Advertisement
Table of Contents
