Table of Contents
Advertisement
3.1: Introduction
The Shark 100 meter can be installed using a standard ANSI C39.1 (4" Round) or an IEC 92mm
DIN (Square) form. In new installations, simply use existing DIN or ANSI punches. For existing
panels, pull out old analog meters and replace with the Shark 100. The various models use the same
installation. See section 3.4 for Shark 100T Installation. See Chapter 4 for wiring diagrams.
Figure 3.1: Shark 100 Face
DIN
Mounting
Brackets
Fig. 3.4: Shark 100 Back Face
Recommended Tools for Shark 100 Installation: #2 Phillips screwdriver, Small wrench and Wire
cutters. Shark 100T Installation requires no tools.
Mount the meter in a dry location, which is free from dirt and corrosive substances. The meter is
designed to withstand harsh environmental conditions. (See Environmental Specifications in
Chapter 2.)
e
Electro Industries/GaugeTech
Chapter 3
Mechanical Installation
Figure 3.2: Shark 100 Dimensions
ANSI Mounting
Rods (Screw-in)
Figure 3.5: ANSI Mounting Panel Cutout
Doc # E145701
Figure 3.3: Shark 100T Dimensions
Figure 3.6: DIN Mounting Cutout
3-1
Hide quick links:
Advertisement
Table of Contents
