Of Load Bar - Electro Industries Shark 100 Installation & Operation Manual

Enter Button:
Menu Button:
Right Button:
Down Button:
Use Buttons in Modes of Operation:
Operating Mode (default): View Parameter Values
Reset Mode: Reset Stored Max and Min Values
Settings Mode: View Meter Setting Parameters and Change Scroll Setting
Configuration Mode: Change Meter Configuration (Can be Password Protected)
NOTE: The above is a brief overview of the use of the Buttons. For Programming, refer to Chapter 7.
For complete Navigation Maps, refer to Appendix A of this manual.

6.2: % of Load Bar

The 10-segment LED bargraph at the bottom of the Shark display provides a graphic representation
of Amps. The segments light according to the load in the %Load Segment Table below.
When the Load is over 120% of Full Load, all segments flash "On" (1.5 secs) and "Off" (0.5 secs).
e
Electro Industries/GaugeTech
Press and release to enter one of four Display Modes
Operating Mode (Default),
Reset Mode (ENTER once, then Down)
Settings Mode (ENTER twice, then Down) and
Configuration Mode (ENTER three times, then Down)
Press and release to navigate Config Menu, return to Main Menu
Operating Mode - Max, Min, %THD, Del kW, Net kW, Total kW
Reset Mode - Yes, No
Settings Mode - On, Off, Settings
Config Mode - Password Digits, Available Values, Digits
Scroll DOWN through Mode menus
% Load Segment Table
Segments
none
1
1 - 2
1 - 3
1 - 4
1 - 5
1 - 6
1 - 7
1 - 8
1 - 9
1 - 10
All Blink
Doc #: E145701
Load >= % Full Load
no load
1%
15%
30%
45%
60%
72%
84%
96%
108%
120%
>120%
6-2