Table of Contents
Advertisement
5.1.2: RS-4 4 85 Communication Com 2 (485 Option)
The Shark 100 meter's RS-485 port uses standard 2-Wire, Half Duplex Architecture.
The RS-485 connector is located on the terminal section of the Shark 100. A connection can easily
be made to a Master Device or to other Slave Devices, as shown below.
Care should be taken to connect + to + and - to - connections.
The Shark 100 meter's RS-485 can be programmed with the buttons on the face of the meter or by
using Communicator EXT 3.0 software.
Standard RS-485 Port Settings:
Address:
Baud Rate:
Protocol:
NOTE: This option is not currently available.
The RS-485 Option is combined with Pulse Output in the RS-485P Option. (See section 5.1.3.)
e
Electro Industries/GaugeTech
Figure 5.2: RS-485 Communication Installation
001 to 247
9600, 19200, 38400 or 57600
Modbus RTU, Modbus ASCII, DNP 3.0 (V3 and V4 Only)
Doc #: E145701
5-2
Hide quick links:
Advertisement
Table of Contents
