7.3.2.1: Enter Password (ONLY IF ENABLED IN SOFTWARE)
To enter a Password:
If PASSWORD is Enabled in the software (see section 5.22 to Enable/Change Password), a
screen appears requesting the Password. PASS appears in the A Screen and 4 dashes in
the B Screen. The LEFT digit is flashing.
Use the DOWN button to scroll from 0 to 9 for the flashing digit. When the correct number
appears for that digit, use the RIGHT button to move to the next digit.
Example: On the Password screens below:
On the left screen, four dashes appear and the left digit is flashing.
On the right screen, 2 digits have been entered and the third digit is flashing.
PASS or FAIL
When all 4 digits have been entered, push ENTER.
If the correct Password has been entered, "rSt ALL donE" appears and the screen returns to
Auto-Scroll the Parameters.
(In other Modes, the screen returns to the screen to be changed. The left digit of the
setting is flashing and the Program (PRG) LED flashes on the left side of the
meter face.)
If an incorrect Password has been entered, "PASS ---- FAIL" appears and the screen returns to
Reset ALL? YES.
e
Electro Industries/GaugeTech
Doc #: E145701
7-3