Grundig GV 470 S VPT User Manual page 67

2. Record Programming
After programming ...
... the recorder accepts data from the video recorder.
The video recorder is in the record stand-by mode and the
drive mechanism buttons are inoperative.
The remaining playing time briefly appears in the video recor-
der´s display (exception: daily or weekly recordings at the
same time).
This is followed by the data of the first TIMER position.
Possible messages in the recorder display
If the display of the recorder shows ...
... REST and F U L L a cassette with insufficient playing time
was inserted.
If the sum of all recording times is
greater than the total playing time of the
inserted cassette, the recorder will
record up to the end of the tape.
The
rewinds the cassette all the way to the
beginning and then switches to stop.
... F U L L
all TIMER positions of the recorder are
occupied.
... REST and — : —
the cassette´s playing time was not
recognised, or a daily/weekly recording
is programmed.
... REST and C A S S no cassette is inserted.
... C O L L
the TIMER recording times overlap
each other.
... E R R O R
the recorder did not receive all the data
from the remote control.
If » CASS N
0
=== « appears in the display of the recorder
instead of the cassette number, you must enter the number if
you want to archive the cassette.
Enter the cassette number as a three digit number with the
numeric buttons ... and confirm with the
The recorder automatically stores » DIVERSE « as the catego-
ry in the archive, as well as the station identification abbrevia-
tion and the start time as title, when the recording starts.
After the recording is completed, you can enter the title of
your choice and assign it to a category; see page 39, section
"Information on Cassette Contents".
recorder then automatically
button.
Variant 3
Checking the TIMER data in the remote control
The » « symbol flashes when all of the data have been sto-
red in the remote control. You can check the data by repea-
tedly pressing the
Correcting TIMER data in the remote control
This can only be done before transmitting the data entries
to the recorder.
Press the button until the respective "data word" (PROG,
OK
DATE, START,
Use the numeric buttons
wish to correct and confirm the remaining data step by step
with the button.
OK
Checking the occupied TIMER positions in the
recorder
The remote control´s display must be switched off.
Select the respective TIMER position by pressing the
button until the corresponding TIME data appear in the dis-
play on the recorder.
The TIMER position data appear in the recorder´s display.
Press the button to conclude.
OK
Erasing an occupied TIMER position in the
recorder
The remote control´s display must be switched off.
Select the respective TIMER position by pressing the
button until the corresponding TIME data appear in the dis-
play on the recorder.
Press the button to clear the data in the TIMER position.
CL
13
button.
OK
or STOP) appears in the display.
... to "overwrite" the data you