Grundig GV 470 S VPT User Manual page 43

7. Record Programming
Possible messages in the dialogue line
If the "Remaining time" is negative (–) and highlighted in red,
then a cassette of insufficient playing time has been loaded,
or the sum of all TIMER recordings is too large.
If the message » Record period « appears instead of
» Remaining playing time, « then...
... no cassette is loaded;
... the cassette is protected against new recording and will be
automatically ejected.
... the playing time of the cassette was not recognized.
If a red line with the message » Record Timer Overlap «
appears (the corresponding TIMER positions are highlighted
in red), then the recording times of the TIMER positions over-
lap.
In this case, change the data of one TIMER position by
pressing the (green) button and selecting the timer
position with the
Select the data to be changed with the
enter the new data, and confirm the data lines step by step
with the button.
When you are still in the "Record Programming" mode, the
message "Record beginning soon" will appear ten minutes
before the beginning of the recording.
If the message » Record start time has passed « appears,
then you must immediately exit the record programming
mode so that the recorder can start recording.
In order to do so, press the
Modifying individual data items of a TIMER posi-
tion
Select the "Info" menu by pressing the
Select the "Record Programming" menu by pressing the
numeric button , and then press the
Select the respective TIMER position by pressing the
button.
Select the data item to be modified by pressing the
button, enter the new data with the numeric buttons
... , and confirm the data lines step by step with the
button.
Clearing TIMER positions
Select the "Info" menu by pressing the
Select the "Record Programming" menu by pressing the
numeric button , and then press the
Select the TIMER position to be cleared with the
button and clear it by pressing the
The TIMER position is cleared and can be programmed again.
Variant 1
or button.
or button,
(TIMER) button.
button.
(green) button.
or
or
button.
(green) button.
or
button.
Interrupting the record stand-by mode of the
recorder
If you have programmed TIMER positions but wish to use the
recorder while it is in record stand-by mode, or you want to
terminate the TIMER recording, then:
press the button on the recorder, the cassette is automa-
tically ejected,
or
press the (TIMER) button.
The TIMER data disappears from the display of the recorder
and the TIMER display flashes.
The record stand-by mode of the recorder is now inter-
rupted.
Now select the desired function.
Reactivating the record stand-by mode of the
recorder
Insert a cassette with sufficient playing time, wait until the
tape measurement is completed, and then press the
(TIMER) button.
The remaining playing time appears briefly in the display of
the recorder.
The recorder is in ready mode again, and the TIMER accord-
ings are made at the set times.
The cassette number also appears briefly in the display.
If » CASS N O
- --- « appears in the display of the recorder
instead of the cassette number, you must enter the number if
you want to archive the cassette.
Enter the cassette number as a three-place number with the
numeric buttons ...
The recorder is once again in the record stand-by mode and
the TIMER recordings will be made at the programmed times.
42
and confirm with the button.