Grundig GV 470 S VPT User Manual page 45

7. Record Programming
Press these buttons on the
remote control
3. Transmitting data to the recorder
4. Confirming the data
Possible messages in the recorder display
If the display of the recorder shows ...
... CODE ERR
this either indicates incomplete data
entry, or
the ShowView number given in the TV
programme guide is incorrect.
... S V ERR
this indicates that no ShowView code is
assigned to a programme position. Per-
form this setting as described on pages
13 through 19.
... DLY ERR
this indicates that you have programmed
a recording for Saturday or Sunday,
which is not possible.
Variant 2
You will see this in the display of the
recorder
28D888 8 I 20:00
P R O G START
SEC PAL C +
S A T DATE
BBCI I 8 I 20:00
P R O G START
SEC PAL C +
S A T DATE
44
Explanations
20:I5
S T O P
VPS
PDC
The recorder converts the ShowView
code to actual recording data.
You can change the stop time.
Each press of the
15 minutes to the current stop time,
and each press of the
ces the current stop time by 15 minu-
tes.
» CODE E R R « appears in the display
if you make incorrect entries. Note
the instructions descriptions on this
page.
If you have programmed a daily or weekly
programme which is always broadcast
at the same time, » E D « (for daily) or
» E W « (for weekly) is shown in the
recorder´s display.
Press the
record the programme without VPS
20:I5
S T O P
.
control
VPS
PDC
button adds
button redu-
button if you want to