Switching The Recorder´s Transmitter On And Off - Grundig GV 470 S VPT User Manual

2. Connecting and Setting Up
1 DECODER A2
Switching the Recorder´s Transmitter Off
and On
If your recorder receives many TV stations between the chan-
nels 30 and 40 in the UHF band, you may experience picture
interference when using your recorder. To avoid this, the
recorder´s transmitter can be switched off.
In order for the picture/sound signal of the recorder to be
passed to the TV set, the two units must be connected by
a EURO-AV cable (see page 8).
H H
L L
Improving the picture quality
If wavy lines are visible on the TV screen, the channel tuned
to is already occupied by a TV station.
In this case, proceed as follows:
Press the button on the recorder.
On the TV set, search for a channel – in the UHF band be-
tween the channels 30 and 40 + 2 channels – which is not
occupied by a TV station (only snow on the picture screen).
Store the channel found in the memory of the TV set (see the
operating instructions for the TV set).
Remove the aerial cable from the socket –
There should be no cassette in the recorder.
Switch to the test pattern by pressing the
recorder.
After a few seconds, the recorder will transmit the test pat-
tern.
Using the alignment pin supplied, turn the channel selector
(FREQ./MOD.) on the back of the recorder (see illustration)
slightly to the right or left until the test pattern appears on the
screen.
Reconnect the aerial cable to the socket –
Complete the adjustment by pressing the
recorder.
Switching the recorder´s transmitter off
Press the button, the numeric buttons
the button.
The transmitter of the recorder is now switched off.
» O F F « appears briefly in the display of the recorder.
Switching the recorder´s transmitter on
Press the button, the numeric buttons
the button.
The transmitter of the recorder is now switched on.
» O N « appears briefly in the display of the recorder.
11
– of the recorder.
II
button on the
– of the recorder.
II
button on the
and
and