Yamaha WR250F(S) Owner's Service Manual page 178

Ê Fasten the diode, rectifier/regulator lead and AC magneto cou-
pler (connected to the CDI unit), with the diode at its white tape
and the rectifier/regulator lead at its protecting tube.
Ë Fasten the wire harness, starter motor lead and negative bat-
tery lead so that the plastic locking tie ends do not contact the
ignition coil lead.
Ì Fasten the wire harness, rectifier/regulator lead, coolant reser-
voir hose, hot starter cable, negative battery lead and starter
motor lead.
Í Fasten the wire harness, negative battery lead, starter motor
lead, rectifier/regulator lead and coolant reservoir hose at the
white tape for the negative battery lead.
Î Fasten the wire harness at its white tape.
Ý 3
Ü F
0
I
Û
0
F
Ù
Ú
H
G
Ù
F
E
D
9
C
Ø
B
×
3
Ö
8
B-B
CABLE ROUTING DIAGRAM
Ï Fasten the wire harness, throttle position sensor lead (in the
wire harness), starter motor lead and negative battery lead.
Ð Make sure that the throttle position sensor coupler does not go
outside the chassis.
Ñ Fasten the throttle position sensor lead.
Ò Pass the carburetor breather hoses, carburetor overflow hose
and coolant reservoir breather hose between the connecting
rod and cross tube (frame).
Ó Fasten the neutral switch lead and oil hose together with the
plastic locking ties and cut off the tie ends.
Ô Pass the cylinder head breather hose through the hose guides.
Õ Fasten the neutral switch lead.
1 È
K
J
2
É
3
Ê
3 Ë
4
3 Ì
5
6
B
B
0
Ô
3
Õ
A
3
0 Ô
2 - 99
SPEC
L
J
Þ
A
3 Í
3
Î 3
Ï
Ð
3
A
8
Ó
9
Ñ
7
Ò