Configuring The Wireless Lan Access Point; Login; Site Contents Of The Access Point - TRENDnet TEW-230APB User Manual

CONFIGURING THE WIRELESS LAN ACCESS POINT

The Wireless Access Point has a Web GUI interface for the
configuration. The AP can be configured through the Web Browser. A
network manager can manage, control and monitor the AP from the
local LAN. This section indicates how to configure the AP to enable
its functions.

Login

Before you configure this device, note that when the AP is configured
through an Ethernet connection, make sure the manager PC must be
set on same IP network. For example, when the default network
address of the default IP address of the AP is 192.168.1.100, then the
manager PC should be set at 192.168.1.x (where x is a number
between 1 and 254), and the default subnet mask is 255.255.255.0.
Open Internet Explorer 5.0 or above Web browser.
Enter IP address http://192.168.1.100 (the factory-default IP address
setting) to the address location.
When there is a screen need to enter the Network password, it means
that there is a password settle, type in the password you entered before.
There is no need to enter any password when you first login the AP,
the default setting is without password.
9

Site Contents of the Access Point

There are seven main functions included in the site contents: Status,
Wireless Settings, TCP/IP Settings, Statistics, Upgrade Firmware,
Save and Reload Settings and Password Settings.
the left side of the menu screen.
Point the selections in
10