Snmp Trap Registration Group - Brocade Communications Systems Brocade 8/12c Reference

SNMP trap registration group

Object and OID
trapMaxClients
1.3.6.1.3.94.2.1
trapClientCount
1.3.6.1.3.94.2.2
trapRegTable
1.3.6.1.3.94.2.3
trapRegEntry
1.3.6.1.3.94.2.3.1
trapRegIpAddress
1.3.6.1.3.94.2.3.1.1
trapRegPort
1.3.6.1.3.94.2.3.1.2
trapRegFilter
1.3.6.1.3.94.2.3.1.3
trapRegRowState
1.3.6.1.3.94.2.3.1.4
TABLE 24
:
System Error Log
errshow command
none (0)
Critical (1)
Error (2)
Warning (3)
Info (4)
Debug (5)
Fabric OS MIB Reference
53-1002151-01
Access
Read only
Read only
Not accessible
Not accessible
Read only
Read only
Read-write
Read-write
trapRegFilter for errorlog severity level
FA-MIB
unknown (1)
critical (4)
error (5)
warning (6)
info (8)
debug (9)

SNMP trap registration group

Description
The maximum number of SNMP trap recipients supported by the
connectivity unit.
Set to 6.
The current number of rows in the trap table.
A table containing a row for each IP address or port number to which
traps are sent.
IP/port pair for a specific client.
The IP address of a client registered for traps.
The UDP port to send traps to for this host. Normally this would be the
standard trap port (162). This object is an index and must be
specified to create a row in this table.
Set to 162.
This value defines the trap severity filter for this trap host. The
connUnit sends traps to this host that have a severity level less than
or equal to this value. The default value of this object is Warning. The
mapping between errorlog severity level and this variable is shown in
Table 24.
For severity level, refer to "FcEventSeverity"
The values 1, 3, 7, and 10 are not valid for SET operations.
Specifies the state of the row. This entry always returns rowActive and
allows for read only. For the state of the row, refer to
9
in Table 22 on page 199.
Table 25.
227