Displaying And Maintaining Ipv4 Vrrp; Configuring Ipv6 Vrrp; Ipv6 Vrrp Configuration Task List; Specifying An Ipv6 Vrrp Operating Mode - HP 6125XLG Configuration Manual

Displaying and maintaining IPv4 VRRP

Execute display commands in any view and the reset command in user view.
Task
Display states of IPv4 VRRP groups.
Display statistics for IPv4 VRRP
groups.
Clear statistics for IPv4 VRRP
groups.

Configuring IPv6 VRRP

This section describes how to configure IPv6 VRRP.

IPv6 VRRP configuration task list

Tasks at a glance
(Required.)
mode
(Required.)
assigning a virtual IPv6 address
(Optional.)
preemptive mode, and tracking function
(Optional.)
(Optional.)
advertisement interval
(Optional.)

Specifying an IPv6 VRRP operating mode

A VRRP group can operate in either of the following modes:
Standard mode—Only the master can forward packets.
•
Load balancing mode—All members that have an AVF can forward packets.
•
After the IPv6 VRRP operating mode is specified on a router, all IPv6 VRRP groups on the router operate
in the specified operating mode.
To specify an IPv6 VRRP operating mode:
Specifying an IPv6 VRRP operating
Creating a VRRP group and
Configuring the router priority,
Configuring VF tracking
Configuring the IPv6 VRRP
Disabling an IPv6 VRRP group
Command
display vrrp [ interface interface-type interface-number [ vrid
virtual-router-id ] ] [ verbose ]
display vrrp statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
reset vrrp statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
Remarks
N/A
N/A
N/A
This configuration applies to only VRRP load balancing
mode.
N/A
N/A
54