Stp Pathcost-Standard - HP A5830 Series Command Reference Manual

Syntax
stp no-agreement-check
undo stp no-agreement-check
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
None
Example
# Enable No Agreement Check on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp no-agreement-check

stp pathcost-standard

Description
Use the stp pathcost-standard command to specify a standard for the device to use when calculating the
default path costs for ports.
Use the undo stp pathcost-standard command to restore the default.
By default, the switch calculates the default path cost for ports based on a private standard.
If you change the standard that the device uses in calculating the default path costs, you restore the path
costs to the default.
Related commands: stp cost and display stp.
Syntax
stp pathcost-standard { dot1d-1998 | dot1t | legacy }
undo stp pathcost-standard
View
System view
Default level
2: System level
Parameters
dot1d-1998: Configures the device to calculate the default path cost for ports based on IEEE 802.1d- 1 998.
dot1t: Configures the device to calculate the default path cost for ports based on IEEE 802.1t.
legacy: Configures the device to calculate the default path cost for ports based on a private standard.
125