Table of Contents
Advertisement
Secure protocols
Enable IPSec
Introduction
'IPsec' is a security protocol that you can use:
•
To limit access to your network to a maximum of 5 hosts.
•
To encrypt the data between the hosts and the system.
Note:
You can enable 'IPsec' in Océ Express WebTools via the printer controller monitor or
via any other networked workstation. For more information on 'IPsec', consult the Se-
curity manual.
Note:
You can only disable 'IPsec' in Océ Express WebTools via the printer controller or via
one of the identified hosts.
Note:
Make sure your 'IPsec' configuration is correct. You may not be able to connect to the
printer as a result of an invalid 'IPsec' configuration. In such cases, you can disable 'IPsec'
on the controller ('Configuration' - 'Connectivity' - 'IPsec generic').
Enable IPSec
Open Océ Express WebTools and log in as 'System administrator'.
1.
Open the 'Configuration' - 'Connectivity' tab.
2.
Go to the 'IPsec generic' bar.
3.
Click on
4.
Change the 'IPsec' setting from 'Disabled' to 'Enabled'.
5.
Note:
'Enable or disable IPsec. IPsec restricts access to the printer over IPv4. It also encrypts
the communication between the hosts and the printer. Note that when IPv6 is enabled
also, traffic over IPv6 is not restricted, nor encrypted.'
Edit in the upper right-hand corner of the section.
Chapter 3 - Define your workflow with Océ Express WebTools
Enable IPSec
77
Advertisement
Table of Contents
