Table of Contents
Advertisement
Turn the Océ PlotWave 900 on and off
The scanner takes about two minutes to warm up. When the system is warmed up, the
message "Ready to copy" appears on the scanner operator panel.
[12] Power switch with key in the timer position on the scanner
Turn the key to the 'Off' position. The scanner is turned 'Off'.
2.
Turn the Océ TDS600 scanner on and off
Set the On/Off switch at the front of the scanner to position (l).
1.
The green LED turns on. The message 'Ready to scan' appears.
[13] On/Off switch at the front of the scanner
Set the On/Off switch at the front of the scanner to position "0". The scanner is off.
2.
22
Chapter 1 - Introduction
Advertisement
Table of Contents
