Table of Contents
Advertisement
Folder
Set the folded package width
Press the "Finishing" card in the "Print" section.
1.
Press the function key "Folded package".
2.
Select 'Width'.
3.
Enter a range between 186 and 230 mm or 7.3 and 9 inches in increments of 1 mm or
4.
0.1 inch; default 210 mm or 9 inches.
Set the folded package length
Press the "Finishing" card in the "Print" section.
1.
Press the function key "Folded package".
2.
Select 'Length'.
3.
Enter a range between 276 and 310 mm or 10.9 and 12.2 inches in increments of 1 mm
4.
or 0.1 inch; default 297 mm or 12 inches
Set the binding strip
Press the "Finishing" card in the "Print" section.
1.
Press the function key "Binding".
2.
Select binding enabled or disabled.
3.
If you selected enabled, enter a range between 15 and 30 mm or 0.6 and 1.2 inches in
4.
increments of 1 mm or 0.1 inch; default 20 mm or 0.8 inch.
Set the reinforcement
Press the "Finishing" card in the "Print" section.
1.
Press the function key "Binding".
2.
Select 'Reinforce' enabled or disabled.
3.
Note:
You can overrule the standard folding program with settings from the printer driver or
the scanner operator panel.
244
Chapter 9 - The Folder, Reinforcement unit and Belt unit
Advertisement
Table of Contents
