Table of Contents
Advertisement
Media types, material and sizes on the printer
Introduction
One of the features of the Océ PlotWave 900 printer is the automatic media change
function. This function enables the printer to switch to another roll of the same media
when there is not enough media on the current roll to finish the print run. Specify media
type and the media size after you load media, as described in
on page
264. The Océ PlotWave 900 supports both DIN and ANSI media formats. See
'Preferred Océ media types and sizes' on page 374
be used on the Océ PlotWave 900 printer.
Set media type
Press the "Online" key on the printer operator panel to put the printer offline. The message
1.
"Offline" is displayed in the status window. The focus shifts to the Media option (indi-
cated by the shadow effect).
[18] The printer operator panel in offline mode
Use the arrow keys to select the roll for which you have just loaded new media.
2.
Press the right selection key to activate the 'Type' option. The dotted line around the
3.
current selection changes into a solid line and the small selection triangles next to the
specified material are no longer dimmed.
Use the arrow keys to select the type you just loaded.
4.
Press the "Online" key to put the printer online again. The printer now knows which
5.
type is used for the specified roll.
Set media material
Press the "Online" key on the printer operator panel to put the printer offline. The message
1.
"Offline" is displayed in the status window.
Media types, material and sizes on the printer
for an overview of all materials that can
Ready to print
Chapter 2 - Get to know the Océ PlotWave 900 system
'Replace/Load a roll of media'
37
Advertisement
Table of Contents
