Table of Contents
Advertisement
AutoDome Junior HD
14. Tighten both clamps using the clamp drive screws
NOTICE!
Over-torquing the ceiling clamps can damage the clamp or
ceiling. Only tighten the clamp until it contacts the ceiling and
you start to feel some resistance. If using a power screwdriver,
set the torque level to the lowest setting.
6.3.3
Installing the Camera to the Mounting Plate
To install the base to a surface or suspended ceiling using the
supplied mounting plate, do the following:
1.
Bosch Security Systems, Inc.
(installed on the assembly) and a #2 Phillips screwdriver.
Figure 6.17 Tighten Mounting Clamps
Loosen the single safety locking screw on the base of the
unit using the user-supplied T-10 Torx wrench.
Figure 6.18 Unlock Safety Locking Screw
Installation Manual
Installing a Recessed Mount | en
F.01U.275.803 | 6.0 | 2012.11
61
Advertisement
Table of Contents
