Installing The Camera To The Mounting Plate - Bosch AutoDome Junior HD VJR Series Operation Manual

18 en | Installing a Surface Mount
4.1.3

Installing the Camera to the Mounting Plate

To install the camera to the mounting plate for a surface or suspended ceiling, do the
following:
1.
2.
3.
4.
5.
Figure 4.4: Unlock Safety Locking Screw
6.
2014.11 | 6.1 | F.01U.275.803
Route wires on side of mounting plate with crescent shaped cut-out (refer to Preparing
the Surface Mount for an Indoor Installation, page 16).
Attach grounding wire from unit to junction box.
Attach user supplied ground to junction box.
Connect the mating connectors with the flying leads to the user supplied wiring (see
Preparing the Wiring, page 39 for wiring information).
Unlock the single safety locking screw on the base of the unit using the user-supplied
Allen wrench.
Plug the matching connectors from the camera into the mating connectors from the
ceiling.
Operation Manual
AutoDome Junior HD Series
Bosch Security Systems, Inc.