Table of Contents
Advertisement
16
en | Installing a Surface Mount
Figure 6.1: Install User-supplied Junction Box
2.
Figure 6.2: Install the Mounting Plate
1
2
3
4
4
6.4
Installing the Camera to the Mounting Plate
To install the camera to the mounting plate for a surface or suspended ceiling, do the
following:
1.
2.
3.
4.
2015.03 | 0.1 |
Secure the mounting plate to the junction box with the user supplied hardware.
Junction Box Holes
Cable Hole (40 mm maximum); Crescent Shape
Mounting Plate
Junction Box
Skip to Installing the Camera to the Mounting Plate, page 16, to continue the installation.
Route wires on side of mounting plate with crescent shaped cut-out (refer to Preparing
the Surface Mount for an Indoor Installation, page 15).
Attach grounding wire from unit to junction box.
Attach user supplied ground to junction box.
Connect the mating connectors with the flying leads to the user supplied wiring (see
Preparing the Wiring for wiring information).
Installation Manual
AUTODOME IP 4000 HD
90 mm
(3.54 in.)
Bosch Security Systems
Advertisement
Table of Contents
