Table of Contents
Advertisement
AutoDome Junior HD
NOTICE!
If you need to install the VJR-A3-SP Support Bracket, refer to
the guide included with the bracket. Once the bracket is
installed, continue with the next section.
6.2.3
Installing the Camera to the Mounting Plate
To install the base to a surface or suspended ceiling using the
supplied mounting plate, do the following:
1.
CAUTION!
All wires for installation applications must be routed through a
grounded conduit.
2.
3.
4.
5.
Bosch Security Systems, Inc.
Loosen the single safety locking screw on the base of the
unit using the user-supplied T-10 Torx wrench.
Figure 6.5 Unlock Safety Locking Screw
Remove the screw from the Earth ground (
of the mounting bracket.
Attach a user-supplied ground wire to the Earth ground
(
) screw hole on the mounting bracket and secure with
the screw.
Attach the green grounding wire from the unit to the
grounded (
) screw hole on the mounting bracket using
the attached captive screw washer.
Route wires on the side of mounting plate with the
crescent shaped cut-out.
Installation Manual
Installing a Recessed Mount | en
F.01U.275.803 | 6.0 | 2012.11
51
)on the top
Advertisement
Table of Contents
