Table of Contents
Advertisement
40
en | Installing a Wall Mount
6.
7.
CAUTION!
All wires for installation applications must be routed through a
grounded conduit.
F.01U.275.803 | 6.0 | 2012.11
Attach the mounting cap to the arm. Using the AutoDome
Junior Outdoor Installation Kit, apply the following O-ring
and the retaining ring to the locations specified below:
Figure 5.5 O-ring and retaining ring placement for outdoor
installation
1
O-ring; 21.82 mm I.D. by Ø3.00 mm
2
Retaining ring with gasket
3
M3 – .5 x 6 Phillips flat head machine screws
a.
Thread the 21.82 mm I.D. by Ø3.00 mm O-ring (item 1,
above) onto the lower arm threads.
b.
Secure the retaining ring gasket (item 2, above) to the
dome cap with the three (3) M3 – .5 x 6 Phillips flat
head machine screws. Ensure that the side of the
retaining ring with the counter-sunk screw holes is
facing you.
c.
Attach the dome cap to the arm mount.
Feed the wires through the hole in the surface, through the
wall mount flat gasket (item 1, Figure 5.6) and then
through the arm.
Installation Manual
AutoDome Junior HD
Bosch Security Systems, Inc.
Advertisement
Table of Contents
