Table of Contents
Advertisement
54
en | Installing a Recessed Mount
10.
NOTICE!
The recessed mounting bracket is provided with an additional
safety tether point. To prevent injury, attach a safety wire from
a secure anchor point above the ceiling to this tether point.
11. Align trim ring so the four alignment posts (item 1, below)
12. Snap trim ring into place. Ensure snaps are secure by
13. Use a T-10 Torx wrench to secure the trim ring's two (2)
F.01U.275.803 | 6.0 | 2012.11
Ensure unit is centered.
align with the recesses in the camera housing (item 2) and
so the two safety screws align with the off center holes
(item 3) on the locking clamps.
Note: The two (2) sets of raised stand-off tabs (item 4) on
each side of the trim ring align with the locking clamps.
Figure 6.9 Align Trim Ring
1
Alignment Tabs (four)
2
Align tabs to the recessed areas on the housing
3
Align safety locking screws to these connections
4
Stand-off Tabs (two)
attempting to lightly turn unit. Note: Unit should not turn.
safety locking screws to the mounting bracket.
Installation Manual
AutoDome Junior HD
Bosch Security Systems, Inc.
Advertisement
Table of Contents
