28
en | Installing a Surface Mount
13. Skip to Section 4.1.4 Installing the Camera to the Mounting
4.1.4
Installing the Camera to the Mounting Plate
To install the camera to the mounting plate for a surface or
suspended ceiling, do the following (certain steps contain
additional information for outdoor installations):
1.
2.
3.
4.
5.
F.01U.164.478 | 2.0 | 2010.02
Plate, page 28, to continue the installation.
Route wires on side of mounting plate with crescent
shaped cut-out (Ref. #2 Figure 4.3).
Attach grounding wire from unit to junction box (see
Figure 4.10).
Attach user supplied ground to junction box.
Connect the mating connectors with the flying leads to the
user supplied wiring (see Section 8 Preparing the Wiring,
page 61 for wiring information).
Unlock the single safety locking screw on the base of the
unit using the user-supplied Allen wrench.
Figure 4.9 Unlock Safety Locking Screw
Installation Manual
AutoDome Easy II
Bosch Security Systems, Inc.