Table of Contents
Advertisement
124 en | Configuring the AutoDome Junior HD
Reboot device
Performs a reboot of the AutoDome. There is a ten (10) second
pause before the dome starts its homing phase. During the
homing phase the camera pans left and right and tilts up and
down. It also adjusts the lens focus. The entire homing phase
lasts approximately 40 seconds.
Factory defaults
Click Restore all defaults to restore the factory defaults for the
camera. A confirmation screen appears. Allow 5 seconds for the
camera to optimize the picture after a mode reset.
View Control
Click the Enable button to access the View Control window.
Use the View Control arrow keys and the zoom keys to establish
the desired view.
NOTICE!
The View Control window is disabled 15 minutes after you open
the window. If the View Control window is disabled, you must
close the window then re-open to resume setting the camera
position and zoom level.
12.17
Encoder Profile
For the video signal encoding, you can select a code algorithm
and you can change the presets for the profiles.
You can adapt the video data transmission to the operating
environment (for example network structure, bandwidth, data
load). To this end, the AutoDome Junior HD simultaneously
generates two data streams (Dual Streaming), which
compression settings you can select individually, for example
one setting for transmissions to the Internet and one for LAN
connections.
Pre-programmed profiles are available, each giving priority to
different perspectives.
F.01U.275.803 | 6.0 | 2012.11
Installation Manual
AutoDome Junior HD
Bosch Security Systems, Inc.
Advertisement
Table of Contents
