Table of Contents
Advertisement
AutoDome Junior HD
12.2
Basic Mode: Date/Time
Device date/Device time/Device time zone
If there are multiple devices operating in your system or
network, it is important to synchronize their internal clocks. For
example, it is only possible to identify and correctly evaluate
simultaneous recordings when all units are operating on the
same time. If necessary, you can synchronize the unit with your
computer's system settings.
Time server IP address
The AutoDome Junior HD can receive the time signal from a
time server using various time server protocols, and then use it
to set the internal clock. The unit polls the time signal
automatically once every minute.
Time server type
Select the protocol that is supported by the selected time
server. Preferably, you should select the SNTP server as the
protocol. This supports a high level of accuracy and is required
for special applications and subsequent function extensions.
Select Time server for a time server that works with the
protocol RFC 868.
12.3
Basic Mode: Network
The settings on this page are used to integrate the AutoDome
Junior HD into an existing network.
Some changes only take effect after the unit is rebooted. In this
case, the Set button changes to Set and Reboot.
1.
2.
Bosch Security Systems, Inc.
Click the Sync to PC button to copy your computer's
system time to the AutoDome Junior HD.
Enter the IP address of a time server here.
Make the desired changes.
Click the Set and Reboot button. The AutoDome Junior HD
is rebooted and the changed settings are activated.
Installation Manual
Configuring the AutoDome Junior HD | en 111
F.01U.275.803 | 6.0 | 2012.11
Advertisement
Table of Contents
