Table of Contents
Advertisement
AutoDome Junior HD
4
Installing a Surface Mount
4.1
Description
This chapter details how to mount the AutoDome Junior to a
hard surface. The AutoDome Junior is also suitable for wall
(Section 5 Installing a Wall Mount, page 34), recess
(Section 6 Installing a Recessed Mount, page 46), and pipe
mounting (Section 7 Installing a Pipe Mount, page 66). For
specific directions on mounting the unit, see the manual that
came with your mount.
For an outdoor installation you must obtain the Surface Mount
Adapter (VEZ-A2-JC or VEZ-A2-JW) and the gaskets and O-rings
supplied with an AutoDome Junior Outdoor Camera to ensure a
water-tight environment inside the unit and to maintain an IP
Environmental Protection Rating. Refer to
Section 4.1.3 Preparing the Surface Mount for an Outdoor
Installation, page 26, to start an outdoor installation.
NOTICE!
The image sensors in modern cameras are highly sensitive and
require special care for proper performance and extended
lifetime. Follow the guidelines for optimum results with your
camera:
–
–
Bosch Security Systems, Inc.
Do not expose to direct sunlight or bright spotlights in
operating and nonoperating conditions.
Avoid bright lights in the field of view of the camera. Bright
lights cause a "smearing" effect, which is visible as white
lines above and below the highlight. Prolonged exposure to
bright lights may cause bleaching of the sensor's color
filters. This will be visible as colored spots in the picture
and is irreversible.
Installation Manual
Installing a Surface Mount | en
F.01U.275.803 | 6.0 | 2012.11
23
Advertisement
Table of Contents
