Table of Contents
Advertisement
AutoDome Junior HD
11.6
Commissioning the AutoDome Junior
Fixed Camera
The remote commissioning feature simplifies installation by
allowing operators to position and zoom the camera via a
remote head-end unit.
This section provides instructions for setting the position and
the zoom level for an AutoDome Junior HD Fixed camera (VJR-
F801 Series).
Using the Built-in Web Server:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. To reset the position and zoom level, repeat these steps.
Bosch Security Systems, Inc.
Launch Microsoft Internet Explorer and navigate to the IP
Address for the AutoDome Junior HD Fixed camera.
The Web browser opens the Livepage.
Type the password for the Service level user.
Click the SETTINGS link in the upper section of the
window.
The Web browser opens a new page with the configuration
menu.
Click the Advanced Link; then click the Camera link,
located in the left pane of the Settings window.
Click the Installer Menu, located under the Camera link.
Click the Open button to the right of View Control to open
the View Control window.
Note: The View Control window is disabled 15 minutes
after you open the window. If the View Control window is
disabled, you must close the window then re-open to
resume setting the camera position and zoom level.
Use the View Control arrow keys and the zoom keys to
establish the desired view.
Note: The AutoDome Junior HD fixed camera pans, tilts,
and zooms at a much slower rate compared to a Pan/Tilt/
Zoom dome camera.
Close the View Control window to set the camera's
position and the zoom level.
Click the LIVEPAGE link, in the upper section of the
window.
Installation Manual
Using the IP Interface | en 103
F.01U.275.803 | 6.0 | 2012.11
Advertisement
Table of Contents
