2
Remove the blue thumbscrew from its existing position on the left tab.
3
Slide the tray sections apart as far as the tab slots allow.
4
Reinstall the blue thumbscrew in the new position on the right tab, securing the tray
extension in the back position.
Replacing the sub-bezel
The installed sub-bezel on the LCP control panel module must be replaced with the new
sub-bezel included with your server.
To replace the sub-bezel:
1
Use a flat-blade screwdriver to lift the metal retention tabs on both sides of the LCP
control panel module, then pull the sub-bezel off of the front of the module.
Warning
2
Align the new sub-bezel with the LCP control panel, then press it until it clicks into
place.
Use a flat-blade screwdriver to lift the metal retention tabs. Failure to
do so could result in injury to fingers or fingernails.
www.gateway.com
Metal retention tabs
101