Additional beep codes provided by optional Intel
Management Modules
In addition to the preceding beep codes, the following additional beep codes are provided
if an Intel Management Module is installed:
Beep Codes
1
1-5-1-1
1-5-2-1
1-5-2-3
1-5-2-4
1-5-4-2
1-5-4-3
1-5-4-4
LED information
The system board in this server includes LEDs that can assist you in troubleshooting your
system. See the following table for a description of these LEDs and the information they
provide:
LED Name
Function
ID
Aid in server
identification
System Fault
Visible fault
warning
ATA drive
Indicate drive
activity
activity
126
Description
Control panel CMOS clear has been initiated
Processor failure. Reseat or replace the failed processor.
No processor is installed or the CPU 1 socket is empty.
Reseat or replace the failed processor.
Processor configuration error or CPU 1 socket is empty.
Reseat or replace the failed processor. In a
two-processor system, make sure the processors are
identical.
Front-side bus select configuration error.
DC power unexpectedly lost.
Chipset control failure.
Power control failure.
Location
Front panel and
left back of
system board
Front panel and
left back of
system board
Front panel and
left side of
system board
www.gateway.com
Color
Description
Blue
On = Server identification
enabled
Green or
On = No fault
■
Orange
Green blink = Degraded
■
Orange = Critical error or
■
non-recoverable
Orange blink = Non critical
■
Green
Blinking = Drive active