Gateway 9415 User Manual page 77

Important
To remove and install a PCI riser connector:
1
Follow the instructions in
sure that you turn off the server, then unplug the power cord(s) and all other cables
connected to the server.
2
Follow the instructions in
3
Remove the PCI riser assembly from the server by following the instructions in
"Removing and installing the PCI riser assembly" on page
4
Remove any installed PCI expansion cards by following the instructions in
and installing a PCI expansion card" on page
Caution
5
Push back on the blue riser locking lever at the end of the PCI riser connector.
PCI riser
connector
6
While holding the lever in, push firmly on the other edge of the PCI riser connector
to disengage the connector from the riser retention pins.
7
Place the PCI riser connector in a static-free bag to store it for future use.
72
To eliminate the possibility of installing the replacement connectors
on the wrong side of the PCI riser assembly, replace one PCI riser
connector at a time.
"Preventing static electricity discharge" on page
"Opening the server case" on page
Do not touch the contacts on the bottom part of the expansion card.
Touching the contacts can cause electrostatic damage to the card.
Riser locking
lever
www.gateway.com
42.
69.
73.
41. Make
"Removing
Riser
retention pin