Table of Contents
Advertisement
12
Remove the PCI riser assembly.
13
Move the shorting block on the Boot Block jumper (J1B1) back to pins 2-3.
14
Replace the PCI riser assembly.
15
Follow the instructions in
Updating the FRU/SDR
The FRU/SDR must be updated whenever you add additional hardware to your server
that must be monitored by the BMC. This includes adding a redundant power supply
module, adding redundant hot-swap fans, or adding an Intel Management Module
(IMM). The FRU/SDR must also be updated whenever you update the BIOS.
Each time you update the FRU/SDR, we recommend that you check
support.gateway.com
available than the one included on the SCCD, download the newer version and use
it instead of the SCCD in the following procedure.
To update the FRU/SDR:
1
Boot your server to DOS (using a DOS-bootable diskette, CD, or USB disk on key).
2
Put the System Companion CD in the CD drive and change directories (to the CD drive)
to access it.
3
When the System Companion CD menu opens, select the FRU/SDR utility.
4
Select one of the following options (if in doubt, choose the second option and update
both):
Update just the SDR repository - Select this option when sensor information needs
to be changed (for example, if the CPU is upgraded to a higher speed or if memory
is replaced).
-OR-
Update the FRUs and the SDR repository (and mBMC TBLs - if the IMM module is
not present) - Select this option if have installed additional hardware (for example,
a redundant power supply or system fans, or additional memory).
5
When you are asked if you have an optional cooling kit installed, type Y if your system
has redundant fans installed or N if you system has only the basic fans installed.
6
Exit the utility, remove the System Companion CD, and reboot your server.
"Closing the server case" on page
for the most current version of the utility. If a newer version is
www.gateway.com
44.
37
Advertisement
Table of Contents
Troubleshooting
