Configuring The Rj-45 Serial Port - Gateway 9415 User Manual

Configuring the RJ-45 serial port

The RJ-45 serial port connector can be configured to support either a Data Set Ready (DSR),
or a Data Carrier Detect (DCD) signal. The default configuration for your server supports
DSR signals. To change the configuration from DSR to DCD signal support, a jumper (J7A1)
must be changed on the system board.
To change the RJ-45 serial port configuration to DCD signal support:
1
Turn off the server, then disconnect the power cords and all other cables connected
to the server.
2
Follow the instructions in
Caution
3
Remove the PCI riser assembly by following the instructions in
installing the PCI riser assembly" on page
4
Remove the jumper across pins 1-3 of jumper J7A1, then place the jumper across
pins 2-4.
5
Reinstall the PCI riser assembly by following the instructions in
installing the PCI riser assembly" on page
6
Follow the instructions in
"Opening the server case" on page
Moving the jumper while the power is on can damage your server.
Always turn off the server and unplug the power cords and all other
cables before changing the jumper.
"Closing the server case" on page
www.gateway.com
69.
69.
44.
42.
"Removing and
"Removing and
23