Table of Contents
Advertisement
3
Connect the USB cable to the control panel module, then slide the module into the
chassis until it clicks into place.
4
Connect the front panel cable to the hot-swap backplane.
5
Replace the bezel by snapping it into place on the front of the server.
Important
6
Follow the instructions in
Reconfiguring the LCP control panel module tray
The LCP control panel module tray must be made longer in order for the control panel
to be flush with the front of the optional bezel.
To reconfigure the LCP control panel module tray:
1
With the LCP control panel module tray removed from the server, locate the blue
thumbscrew that secures the tray extension in position on the module tray.
LCP control panel
module tray
100
If you are replacing the standard control panel module with the
optional LCP control panel module and decide to use the optional
bezel, you are required to reconfigure the LCP module for use with
the bezel. For information on reconfiguring the LCP control panel
module tray, see
"Reconfiguring the LCP control panel module tray"
on page
100.
"Closing the server case" on page
Tray extension
www.gateway.com
Existing position of the
blue thumbscrew (on
the left tab)
Tab slot
44.
New position of the
blue thumbscrew (on
the right tab)
Advertisement
Table of Contents
Troubleshooting
