Gateway 9415 User Manual page 99

7
Slide the backplane to the left until it stops.
8
Holding the backplane by the edges only, lift it from the chassis.
Caution
9
Place the backplane in a static-free bag to store it for future use.
10
Holding the new backplane by the edges only, align it with the stand-offs on the
chassis, then place it on the stand-offs and slide it to the right until it stops.
Caution
Caution
11
Tighten the blue captive thumbscrew in the center of the backplane.
12
Reconnect all cables to the backplane.
13
Follow the instructions in
14
Reinstall the hot-swap drives back into the server. Make sure that you install the drives
into the same bays you removed them from in
a hard drive" on page
15
Replace the bezel by snapping it into place on the front of the server.
94
Pressing or pulling on any components on the backplane could result
in damage to the backplane.
Pressing or pulling on any components on the backplane could result
in damage to the backplane.
Make sure you do not pinch, bind, or damage any cables as you install
the backplane.
"Closing the server case" on page
60.
www.gateway.com
44.
Step 4. For instructions see "Installing