Preparing to install components
Selecting a place to work
Work on your server in an area that:
■
Is clean (avoid dusty areas).
■
Is a low-static environment (avoid carpeted areas).
■
Has a stable surface on which to set your server.
■
Has enough room to place all of your server parts.
■
Is near a grounded outlet so you can test your server after installation.
■
Is near a telephone (in case you need help from Gateway Customer Care). The
telephone must be directly connected to a telephone jack and cannot be connected
to your server.
Gathering the tools you need
Some tools and supplies that you may need to work on your server are:
■
A notebook to take notes
■
A Phillips screwdriver
■
A small flat-blade screwdriver
■
Small containers to store various types of screws
■
A grounding wrist strap (available at most electronic stores)
Tips & Tricks
Getting Help
If you have questions about performing any of these procedures, contact Gateway
Customer Care. For more information, see
40
Blue latches, thumbscrews, or connectors indicate tool-less
components.
Green latches and connectors indicate hot-swappable components.
www.gateway.com
"Getting Help" on page
8.