Gateway 9415 User Manual page 92

6
Find the IMM connector on the left back portion of the system board.
Hole for standoff
7
Grasp the module by the edges, close to the mounting connector, align the module
with the IMM connector on the system board, then gently apply pressure to seat the
module.
Caution
Make sure the module is fully seated and the nylon standoff is inserted into the
corresponding hole in the system board.
8
Replace the riser assembly by following the instructions in
the PCI riser assembly" on page
9
Follow the instructions in
10
Following the installation of a new IMM module, reinstall the GSM software (supplied
on a CD with your server) and update the FRU/SDR (see
page 37). When you subsequently reboot your server, the GSM software will take over
management of the server.
IMM connector
Exercise extreme caution when installing the IMM module. The
module is fragile and can be damaged easily.
69.
"Closing the server case" on page
www.gateway.com
"Removing and installing
44.
"Updating the FRU/SDR" on
87